Unkown



MOTTLED PRINT

Mottled print is a common problem , when trying to print good quality consistent solids in flexo. The surface of the print appears like orange peel, with inconsistent colour and non-uniform appearance

Cause
Printing form with uneven or un-clean surface
Ink viscosity or concentration, too low
Residual chemicals from the plate-making process, still on surface
Dirty or scratched impression cylinder
In-correct ink transfer on the printing form or substrate
Ink not wetting on printing form or substrate

Solution
1 Increase the printing pressure between the printing form and substrate
2 Increase the ink viscosity or ink film thickness.
3 Modify ink to correct viscosity or opacity. Check the balance of solvent in the ink. If necessary change the ink
4 Wash the printing form to remove residual chemicals. If necesary remake the printing form
5 Properly clean the impression cylinder
6 Use softer or more compatible plate or cushion tape
7 Check surface treatment of the substrate


Helmut Mathes, troubleshooting defects supplied curtesey of Flexo & Gravure Int''l 2011

INK TRANSFER - ANILOX

The shape and consistency of anilox cells makes a huge impact on ink transfer and cleanliness of the inking process to the printing plate.

Read more

DIRTY ANILOX

Dried ink in anilox cells, can cause significant change in print densities. The FlexoStar laser can clean dried ink from even the smallest cells.

Read more
Save time, save money

Save time, save money

The only thing you need is a simple digital workflow. Pre-press Rip creates a 1 bit TIFF input for the laser engraver (seamless is possible). The laser calculates dot formation during engraving.